KING ADHESIVES CORP -- DUCT LINER ADHESIVE 15-146  -- 8040-00F038281
<pre>=====================  Product Identification  =====================

Product ID:DUCT LINER ADHESIVE 15-146
MSDS Date:08/06/1991
FSC:8040
NIIN:00F038281
=== Responsible Party ===
Company Name:KING ADHESIVES CORP
Address:5231 NORTHRUP AVE
City:ST LOUIS
State:MO
ZIP:63110-5000
Country:US
Info Phone Num:314-772-9953/800-233-8171
Emergency Phone Num:314-772-9953/800-233-8171
CAGE:KINGG
=== Contractor Identification ===
Company Name:KING ADHESIVES CORP
Address:5231 NORTHRUP AVE
Box:City:ST LOUIS
State:MO
ZIP:63110-5000
Country:US
Phone:314-772-9953/800-233-8171
CAGE:KINGG

=============  Composition/Information on Ingredients  =============

Ingred Name:HEXANE, N-HEXANE
CAS:110-54-3
RTECS #:MN9275000
Fraction by Wt: 65-68%
Other REC Limits:50 PPM
OSHA PEL:1800 MG/CUM
ACGIH TLV:176 MG/CUM
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

Ingred Name:VOL ORGANIC CMPD:  497.2 GRAMS
RTECS #:9999999VO

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:EYES: SEVERE IRRITATION. SKIN:
    MODERATE IRRITATION/DERMATITIS. INHALATION: NASAL & RESPIRATORY
    IRRITATION/ASPHYXIATION. INGESTION: GASTROINTESTINAL IRRITATION.
    ASPIRATION OF THE MATERIAL INTO THE LUNG S DUE TO VOMITING, CAN
    CAUSE CHEMICAL PNEUMONITIS, WHICH CAN BE HARMFUL/FATAL.
    OVEREXPOSURE MAY CAUSE POLYNEUROPATHY.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, REDNESS, TEARING, BLURRED VISION,
    DEFATTING, WEAKNESS, FATIGUE, NAUSEA, HEADACHE, UNCONSCIOUSNESS,
    ASPHYXIATION, VOMITING, DIARRHEA

=======================  First Aid Measures  =======================

First Aid:EYES: FLUSH W/LARGE AMOUNTS OF WATER/SALINE SOLUTION FOR 15
    MINS. SKIN: WASH THOROUGHLY W/A WATERLESS HAND CLEANER & THEN
    W/SOAP & WATER. INHALATION: MOVE TO FRESH AIR. GIVE OXYGEN/CPR IF
    NECESSARY. K EEP PERSON WARM & QUIET. NEVER GIVE ANYTHING BY MOUTH
    IF UNCONSCIOUS. INGESTION: ASPIRATION HAZARD. DON'T INDUCE
    VOMITING. OBTAIN MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:-25F
Lower Limits:1
Upper Limits:7.7
Extinguishing Media:REGULAR FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS W/FULL
    FACE PIECE MSHA/NIOSH JOINTLY APPROVED IN A PRESSURE DEMAND/OTHER
    POSITIVE PRESSURE MODE.
Unusual Fire/Explosion Hazard:HIGHLY VOLATILE, GIVES OFF VAPORS WHICH
    ARE >AIR & MAY TRAVEL ALONG THE GROUND/BE MOVED BY VENTILATION
    SYSTEMS TO BE IGNITED BY HEAT/SPARKS & IGNITION SOURCES.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SMALL: ABSORB ON PAPER/VERMICULITE/OTHER
    ABSORBENT & ALLOW TO EVAPORATE. DISPOSE OF DRY MATERIAL. LARGE:
    ELIMINATE ALL IGNITION SOURCES. EVACUATE ALL UNPROTECTED PERSONNEL.
    STOP LEAK AT SOURCE & DIKE	AREA TO PREVENT FROM SPREADING. (SEE
    SUPP)

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP AWAY FROM ALL IGNITION SOURCES;
    HEAT/PILOT LIGHTS/FLAMES/SPARKS/STATIC ELECTRICITY. KEEP HANDLING &
    STORAGE AREA WELL VENTILATED.
Other Precautions:KEEP CONTAINER SEALED WHEN NOT IN USE. DON'T STORE
    NEAR STRONG OXIDIZERS. DON'T TRANSFER TO AN UNMARKED CONTAINER.
    CONTAINERS SHOULD BE ELECTRICALLY GROUNDED WHEN TRANSFERRING
    MATERIAL. EMPTY CONTAINE RS MAY CONTAIN HAZARDOUS RESIDUE.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF THE TLV IS EXCEEDED, A MSHA/NIOSH JOINTLY
    APPROVED RESPIRATOR/AIR SUPPLIED REGULATOR IS NECESSARY.
Ventilation:SUFFICIENT MECHANICAL TO MAINTAIN AIR CONCENTRATIONS BELOW
    TLVS
Eye Protection:OSHA APPROVED SPLASH GOGGLES/OTHER
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
    REUSE.
Supplemental Safety and Health
SPILL PROC CONT'D: PUMP LIQUID INTO SALVAGE TANK. RESIDUE CAN BE
    CLEANED UP W/ABSORBENT MATERIAL.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:149F
Vapor Pres:125
Vapor Density:3
Spec Gravity:0.754
Evaporation Rate &amp; Reference:(N BU AC=1): 5.1
Solubility in Water:NEGLIGIBLE
Appearance and Odor:LIGHT TAN COLOR, THIN VISCOSITY W/MILD NAPHTHA-LIKE
    ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HEAT, OPEN FLAMES, PILOT LIGHTS, SPARKS,
    STATIC DISCHARGE, ELECTRIC MOTORS, OTHER IGNITION SOURCES

====================  Disposal Considerations  ====================

Waste Disposal Methods:ABSORBENT MAY BE LAND-FILLED IN ACCORDANCE
    W/LOCAL, STATE & FEDERAL REGULATIONS. NA 1133 FLAMMABLE LIQUID.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.