HERCULES CHEMICAL CO INC -- HERCULES DARK CUTTING OIL -- 9150-00-252-6371
===================== Product Identification ===================== Product ID:HERCULES DARK CUTTING OIL MSDS Date:06/25/1990 FSC:9150 NIIN:00-252-6371 Status Code:A === Responsible Party === Company Name:HERCULES CHEMICAL CO INC Address:111 SOUTH STREET(OLD IS 29 W 38 ST) City:PASSAIC State:NJ ZIP:07055-7398 Country:US Info Phone Num:973-778-5000 Emergency Phone Num:973-778-5000 Resp. Party Other MSDS Num.:MATERIAL SAFETY DATA SHEET # 44 CAGE:84794 === Contractor Identification === Company Name:HERCULES CHEMICAL CO INC Address:111 SOUTH STREET(OLD IS 29 W 38 ST) Box:City:PASSAIC State:NJ ZIP:07055-7398 Country:US Phone:973-778-5000 CAGE:84794 ============= Composition/Information on Ingredients ============= Ingred Name:PETROLEUM-BASED LUBRICATING OILS CAS:64742-52-5 RTECS #:PY8035000 OSHA PEL:5 MG/M3 (OIL MIST ACGIH TLV:5 MG/M3 (OIL MIST) Ingred Name:PETROLEUM-BASED LUBRICATING OILS CAS:64742-53-6 RTECS #:PY8036000 OSHA PEL:5 MG/M3 (OIL MIST) ACGIH TLV:5 MG/M3 (OIL MIST) ===================== Hazards Identification ===================== LD50 LC50 Mixture:NO DATA PROVIDED BY MANUFACTURER Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO Health Hazards Acute and Chronic:PRODUCT HAS A LOW ORDER OF ORAL AND DERMAL TOXICITY. POSSIBLE ASPIRATION HAZARD. INDUCED VOMITING MAY CAUSE ASPIRATION OF PRODUCT INTO LUNGS. Explanation of Carcinogenicity:NO DATA PROVIDED BY MANUFACTURER Effects of Overexposure:SKIN: MODERATE IRRITANT AND SKIN DEFATTER. EYE: MILD (TRANSIENT) IRRITANT. PROLONGED OR REPEATED SKIN CONTACT WITH PRODUCT TENDS TO REMOVE SKIN OILS POSSIBLY LEADING TO IRRITATION AND DERMATITIS, HOWE VER BASED ON HUMAN EXPERIENCE AND AVAILABLE TOXICOLOGICAL DATA, THIS PRODUCT IS JUDGED TO BE NEITHER A "CORROSIVE" OR AN "IRRITANT" BY OSHA CRITERIA. VARIABILITY AMONG INDIVIDUALS: HEALTH STUDIES HAVE SHOWN THAT MANY PETROLLEUM HYDROCARBONS AND SYNTHETIC LUBRICANTS POSE POTENTIAL HUMAN HEALTH RISKS WHICH VARY FROM PERSON TO PERSON. AS A PRECAUTION, EXPOSURE TO LIQUIDS, VAPORS, MIST OR FUMES SHOULD BE MINIMIZED. Medical Cond Aggravated by Exposure:NONE KNOWN ======================= First Aid Measures ======================= First Aid:INHALATION: VAPOR INHALATION UNDER AMBIENT CONDITIONS IS NORMALLY NOT A PROBLEM. IF OVERCOME BY VAPOR FROM HOT PRODUCT, IMMEDIATELY REMOVE TO FRESH AIR IF NOT BREATHING. GET MEDICAL ATTENTION. INGESTI ON: DO NOT INDUCE VOMITING. GET MEDICAL ATTENTION. SKIN: WASH SKIN THOROUGHLY WITH SOAP AND WATER AND REMOVE CONTAMINATED CLOTHING. EYE: FLUSH WITH PLENTY OF WATER FOR 15 MINUTES OR UNTIL IRRITATION S UBSIDES. IF IRRITATION PERSISTS, GET MEDICAL ATTENTION. ===================== Fire Fighting Measures ===================== Flash Point Method:COC Flash Point:=160.C, 320.F Lower Limits:1% Upper Limits:6% Extinguishing Media:DRY CHEMICAL, CO2, FOAM. USE WATER TO KEEP FIRE-EXPOSED CONTAINERS COOL. Fire Fighting Procedures:RECOMMEND SCBA (SELF CONTAINED BREATHING APPARATUS) SUPPLIED AIR BREATHING GEAR WHEN FIRE FIGHTING IS CONFINED SPACES. MINIMIZE BREATHING GASES, VAPOR, FUMES, OR DECOMPOSITION PRODUCTS. WATER FROTH MA Y BE USED TO FLUSH SPILLS AWAY FROM EXPOSURE. Unusual Fire/Explosion Hazard:NONE ================== Accidental Release Measures ================== Spill Release Procedures:HANDLE AS AN OIL SPILL. USE OIL ABSORBING MATERIAL. SWEEP & SCOOP UP & REMOVE. PREVENT SPREAD OF SPILL. KEEP PRODUCT FROM SEWERS & WATER COURSES BY DIKING, ETC. ADVISE AUTHORITIES IF PRODUCT HAS ENTER ED OR MAY ENTER SEWER, WATER COURSES, OR EXTENSIVE LAND AREAS. ASSURE CONFORMITY WITH LOCAL REGULATIONS. Neutralizing Agent:NO DATA PROVIDED BY MANUFACTURER ====================== Handling and Storage ====================== Handling and Storage Precautions:NO SPECIAL PRECAUTIONS NEEDED NORMALLY. HOWEVER, AVOID BREATHING OIL MIST AND EXCESSIVE SKIN CONTACT. Other Precautions:NONE ============= Exposure Controls/Personal Protection ============= Respiratory Protection:IF POSSIBILITY OF OIL MISTS EXISTS, USE NIOSH APPROVED MASK FOR OIL MISTS. Ventilation:LOCAL EXHAUST: AS NEEDED TO MAINTAIN COMPLIANCE WITH TLV Protective Gloves:RUBBER GLOVES - OIL RESISTANT Eye Protection:GOGGLES IF OIL IS BEING SPRAYED OR SPLASHED Other Protective Equipment:GLOVES IF PROLONGED SKIN CONTACT CANNOT BE AVOIDED Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING. MINIMIZE BREATHING OF VAPOR MIST, FUMES. REMOVE CONTAMINATED CLOTHING, LAUNDER OR DRY CLEAN. Supplemental Safety and Health NO DATA PROVIDED BY MANUFACTURER ================== Physical/Chemical Properties ================== HCC:V5 Boiling Pt:B.P. Text:465 TO 900 DEG F Vapor Pres:<0.1 MMHG @ 38 DEG C Vapor Density:>8(AIR=1) Spec Gravity:.906 @ 25 DEG C (H2O=1) Solubility in Water:INSOLUBLE Appearance and Odor:DARK BROWNISH AMBER LIQUID, PETROLEUM ODOR ================= Stability and Reactivity Data ================= Stability Indicator/Materials to Avoid:YES STRONG OXIDIZERS SUCH AS LIQUID CHLORINE, SODIUM OR CALCIUM HYPOCHLORITE, AND PURE OXYGEN Stability Condition to Avoid:OPEN FLAMES, SPARKS, IGNITION SOURCES Hazardous Decomposition Products:CARBON MONOXIDE, OXIDES OF SULFUR AND OTHER DECOMPOSITION PRODUCTS MAY FORM UPON INCOMPLETE COMBUSTION Conditions to Avoid Polymerization:WILL NOT OCCUR =================== Toxicological Information =================== Toxicological Information:NO DATA PROVIDED BY MANUFACTURER ===================== Ecological Information ===================== Ecological:NO DATA PROVIDED BY MANUFACTURER ==================== Disposal Considerations ==================== Waste Disposal Methods:ASSURE CONFORMITY WITH APPLICABLE DISPOSAL REGULATIONS. DISPOSE OF ABSORBED MATERIAL AT AN APPROVED WASTE DISPOSAL SITE OR FACILITY. =================== MSDS Transport Information =================== Transport Information:NO DATA PROVIDED BY MANUFACTURER ===================== Regulatory Information ===================== SARA Title III Information:NO DATA PROVIDED BY MANUFACTURER Federal Regulatory Information:NO DATA PROVIDED BY MANUFACTURER State Regulatory Information:NO DATA PROVIDED BY MANUFACTURER ======================= Other Information ======================= ====================================================================== Disclaimer (provided with this information by the compiling agencies): This information is formulated for use by elements of the Department of Defense. The United States of America in no manner whatsoever, expressly or implied, warrants this information to be accurate and disclaims all liability for its use. Any person utilizing this document should seek competent professional advice to verify and assume responsibility for the suitability of this information to their particular situation.