DEL PAINT MFG -- ENAMEL  -- 8010-00-297-2010
<pre>=====================  Product Identification  =====================

Product ID:ENAMEL
MSDS Date:11/17/1995
FSC:8010
NIIN:00-297-2010
Status Code:A
=== Responsible Party ===
Company Name:DEL PAINT MFG
Address:3105 EAST RENO
City:OKLAHOMA CITY
State:OK
ZIP:73117
Country:US
Info Phone Num:405-672-1431
Emergency Phone Num:1-800-424-9300
Preparer's Name:ERNEST CARTER
Chemtrec Ind/Phone:(800)424-9300
CAGE:39934
=== Contractor Identification ===
Company Name:DEL PAINT MFG
Address:3105 EAST RENO
Box:City:OKLAHOMA CITY
State:OK
ZIP:73117
Country:US
Phone:405-672-1431
CAGE:39934

=============  Composition/Information on Ingredients  =============

Ingred Name:METHYL ALCOHOL
CAS:67-56-1
RTECS #:PC1400000
&gt; Wt:.33
OSHA PEL:260 MG/M3;200 PPM
ACGIH TLV:262 MG/M3;200 PPM
ACGIH STEL:328 MG/M3;250 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:NAPHTHA, SOLVENT
CAS:8052-41-3
RTECS #:WJ8925000
= Wt:44.89
OSHA PEL:2900 MG/M3;500 PPM
ACGIH TLV:525 MG/M3;100 PPM

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:UNKNOWN  Ingestion:YES
Health Hazards Acute and Chronic:DERMAL, INHALATION, INGESTION
Effects of Overexposure:VAPORS ARE INTOXICATING AND NARCOTIC THEY ALSO
    CAUSE IRRITATION TO THE MUCOUS MEMBRANES OF THE LUNG, SKIN CONTACT
    PRODUCES REDNESS EYE CONTACT PRODUCES REDNESS AND PAIN.
Medical Cond Aggravated by Exposure:DISEASES OF THE RESPIRATORY SYSTEM

=======================  First Aid Measures  =======================

First Aid:IF INGESTED: SKIN-REMOVE CONTAMINATED CLOTHING SHOWER OR
    RINSE SKIN WITH PLENTY OF WATER EYE-RINSE WITH COPIUS AMOUNTS OF
    WATER, TRANSPORT TO PHYSICIAN IF NECESSARY: INHALATION-REMOVE TO
    FRESH AIR. IN GESTION-RINSE MOUTH AND DRINK PLENTY OF WATER.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:=37.8C, 100.F
Lower Limits:0.9
Extinguishing Media:FOAM, ALCOHOL, FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:SELF-CONTAINED BREATHING APPARATUS WITH A FULL
    FACEPIECE OPERATED IN PRESSURE-DEMAND OR OTHER POSITIVE MODE.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR AND MAY
    TRAVEL ALONG THE GROUND OR MAY BE MOVED BY VENTILATION AND IGNITED
    BY PILOT LIGHTS. AND OTHER FLAMES. SPARKS. HEATERS.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ABSORB LIQUID ON PAPER, VERMICULITE, FLOOR
    ABSORBENT, OR OTHER ABSORBENT MATERIAL AND TRANSPER TO HOOD.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN A CLEAN DRY AREA. KEEP AWAY
    FROM FOOD PRODUCTS KEEP AWAY FROM SPARKS, FIRES AND REMOTE IGNITION
    SOURCES
Other Precautions:THE INFORMATION ACCUMULATED HEREIN IS BELIEVED TO BE
    ACCURATE BUT IS NOT WARRANTED TO BE WHETHER ORGINATING WITH DEL
    PAINT OR NOT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV OF THE PRODUCT OR ANY COMPONENT IS
    EXCEEDED, A NIOSH/MSHA JOINLY APPROVED AIR SUPPLIED RESPIRATOR IS
    ADVISED IN ABSENCE OF PROPER ENVIRONMENTAL CONTROL.
Ventilation:PROVIDE VENTILATION SUFFICIENT TO MAINTAIN EXPOSURE BELOW
    TLV'S,
Protective Gloves:WEAR RESISTANT GLOVES SUCH AS BUNA-N
Eye Protection:SPLASH GOGGLES OR SAFETY GLASSES (CONSULT YOUR SAFETY
    EQUIPMENT SUPPLIER)
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
    CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS
Work Hygienic Practices:WASH HANDS AND FACE BEFORE EATING
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:=182.2C, 360.F
Vapor Density:HEAVIER
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:64.85

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:DO NOT STORE NEAR HEATED SURFACES, OPEN
    FLAMES, OR IGNITION SOURCES.
Hazardous Decomposition Products:CARBON DIOXIDE AND WATER ARE FORMED ON
    COMBUSTION
Conditions to Avoid Polymerization:WILL NOT OCCUR

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSAL OF WASTE MATERIAL MUST COMPLY WITH
    FEDERAL, STATE AND LOCAL REGULATION IF APPROVED, IT MAY BE REMOVED
    TO LICENSED LAND FILL

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.